Genericmusic Posted February 25, 2014 Share Posted February 25, 2014 You do good work. Link to comment Share on other sites More sharing options...
Steiner Posted February 25, 2014 Share Posted February 25, 2014 Bravo! Link to comment Share on other sites More sharing options...
H Posted February 25, 2014 Share Posted February 25, 2014 Another nice job! Link to comment Share on other sites More sharing options...
rockabilly69 Posted February 25, 2014 Share Posted February 25, 2014 Good looking cab! Link to comment Share on other sites More sharing options...
SouthpawGuy Posted February 25, 2014 Share Posted February 25, 2014 Good stuff Link to comment Share on other sites More sharing options...
Gitfiddler Posted February 25, 2014 Share Posted February 25, 2014 Solid!! Link to comment Share on other sites More sharing options...
bobmeyrick Posted February 25, 2014 Author Share Posted February 25, 2014 Thanks everyone! This time I went out and bought some wood, rather than just using what was lying around. The top, bottom and sides are 18mm Baltic birch plywood, while the baffle and rear panel are 15mm. This time I used rebate (rabbet) and dado joints like this - Relatively straightforward to do with a router and quite strong once glued up. However I did reinforce the joints with 20mm square pine battens. Link to comment Share on other sites More sharing options...
DetroitBlues Posted February 25, 2014 Share Posted February 25, 2014 Awesome idea on the joints! Link to comment Share on other sites More sharing options...
smokedtires Posted March 2, 2014 Share Posted March 2, 2014 Very nice work! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.